DB2 Version 9.7 for Linux, UNIX, and Windows
Installation methods that require manual configuration (Linux and UNIX) > Manually configuring DB2 servers after installation > Creating group and user IDs in a partitioned database environment >

Creating required users for a DB2 server installation in a partitioned database environment (AIX®)

Three users and groups are required to operate a DB2® database. The user and group names used in the following instructions are documented in the following table. You can specify your own user and group names if they adhere to your system naming rules and DB2 naming rules.

If you are planning to use the DB2 Setup wizard to install your DB2 product, the DB2 Setup wizard will create these users for you.

Table 25. Required users and groups
Required user User name Group name
Instance owner db2inst1 db2iadm1
Fenced user db2fenc1 db2fadm1
DB2 administration server user dasusr1 dasadm1

If the DB2 administration server user is an existing user, this user must exist on all the participating computers before the installation. If you use the DB2 Setup wizard to create a new user for the DB2 administration server on the instance-owning computer, then the new user is also created (if necessary) during the response file installations on the participating computers. If the user already exists on the participating computers, the user must have the same primary group.

Prerequisites
Restriction
The user names you create must conform to both your operating system's naming rules, and those of DB2.

To create all three of these users, perform the following steps:

  1. Log on to the primary computer.
  2. Create a group for the instance owner (for example, db2iadm1), the group that will run UDFs or stored procedures (for example, db2fadm1), and the group that will own the DB2 administration server (for example, dasadm1) by entering the following commands:
       mkgroup id=999 db2iadm1
       mkgroup id=998 db2fadm1
       mkgroup id=997 dasadm1
  3. Create a user that belongs to each group that you created in the previous step using the following commands. The home directory for each user will be the DB2 home directory that you previously created and shared (db2home).
    mkuser id=1004 pgrp=db2iadm1 groups=db2iadm1 home=/db2home/db2inst1
       core=-1 data=491519 stack=32767 rss=-1 fsize=-1 db2inst1
    mkuser id=1003 pgrp=db2fadm1 groups=db2fadm1 home=/db2home/db2fenc1 
       db2fenc1 
    mkuser id=1002 pgrp=dasadm1 groups=dasadm1 home=/home/dasusr1    
       dasusr1
  4. Set an initial password for each user that you created by entering the following commands:
       passwd db2inst1
       passwd db2fenc1
       passwd dasusr1
  5. Log out.
  6. Log on to the primary computer as each user that you created (db2inst1, db2fenc1, and dasusr1). You might be prompted to change each user's password because this is the first time that these users have logged onto the system.
  7. Log out.
  8. Create the exact same user and group accounts on each computer that will participate in your partitioned database environment.
[ Top of Page | Previous Page | Next Page | Contents ]