DB2 Version 9.7 for Linux, UNIX, and Windows

Installing, updating, and uninstalling DB2 High Availability Disaster Recovery (HADR) scripts for the IBM Tivoli System Automation for Multiplatforms (SA MP) using DB2 installer

Before you begin

Whether you use the DB2 installer or manually install, upgrade, or uninstall SA MP HADR scripts, you must meet the basic prerequisites for installing, upgrading, and uninstalling SA MP HADR scripts. See: Installing, updating, and uninstalling DB2 High Availability Disaster Recovery (HADR) scripts for the IBM Tivoli System Automation for Multiplatforms (SA MP).

About this task

There are three methods for using the DB2 installer:

• DB2 Setup wizard (install, upgrade, or uninstall)
• Silent install using a response file with db2setup (install or upgrade) or db2unins (for uninstall)
• db2_install command (for install), installFixPack command (for upgrade), or db2_deinstall command (for uninstall)

Procedure

1. To install SA MP HADR scripts, run the DB2 installer.

   By default, the DB2 installer installs SA MP HADR scripts if SA MP is installed or being installed, and the scripts are not already installed.

2. To upgrade the SA MP HADR scripts, run the DB2 installer.

   By default, the DB2 installer will upgrade SA MP HADR scripts if SA MP is installed or being installed, and the scripts that are already installed are at a lower version than the version of the scripts that are on the IBM Data Server install media.

3. To uninstall SA MP HADR scripts, run the DB2 installer.

Results

Whether you use the DB2 installer or manually install, upgrade, or uninstall SA MP HADR scripts, the general results are the same, see: Installing, updating, and uninstalling DB2 High Availability Disaster Recovery (HADR) scripts for the IBM Tivoli System Automation for Multiplatforms (SA MP).